Please enable JavaScript to view this site.

MESYS Calculation Software

Navigation: MESYS Shaft Calculation

Interface to rolling bearing calculation

Scroll Prev Top Next More

The dialogs of the MESYS Rolling Bearing Calculation are fully integrated into the shaft calculation.

all_img123

While the bearing calculation is open, the functions for file operations, calculation and report generation are used for the bearing calculation only. Therefore, only the bearing will be calculated and you will get results for the bearing in the results overview. However, it exists the possibility to run the whole shaft calculation, while the bearing calculation is in use, by pressing the key combination CTRL+F5.

Graphics and the tolerance report can be opened using the right mouse button in the system tree. Graphics are also available in the menu for graphics. Graphics from different bearings can be shown at the same time.